[cdsouth]

Hi all. I'm new to the forum. I appreciate all the good info I have learned from reading your posts. I have installed the Rox 2 inch risers for my handlebars. (Thanks for the posts that showed me how). The problem is that my left turn signal will not work now. Any suggestions?

 

[Prgrmerror]

It’s been a little while but I seem to remember I had to unplug my signals. Did you plug it back in or maybe you did but it needs to be reseated? I know that’s basic but that’s all I can think of.

 

[cdsouth]

I have unplugged and reseated all the connections. I checked all the fuses just to be sure. I can't find any obvious disruption in the line.

 

[cdsouth]

Additional info: the emergency flashers work on both sides, but turn signal only works on right. I've checked and the switch itself is not the problem. Does anyone know the full path of the wire from the turn signal switch?

 

[Prgrmerror]

Sorry I’m worthless with a schematic. There are a few guys here that may be able to help. Let’s hope one comes along soon.

 

[Keywasted]

I found out which wire goes where while installing my turn signal beeper. The left turn signal wire is orange. This thread may help.
Best of luck.
http://www.f6cforum.com/forum/8-honda-f6c-general-discussion/11377-turn-beeper.html

 

[cdsouth]

Well I finally got back to my turn signal issue. Thanks for the posts. I checked continuity and found a stretch of wire with no continuity. After untaping the harness, I found that I had managed to cut the left turn signal wire, evidently when I cut one of the zip ties holding the harness in place. I'm surprised because I thought I was being careful. All is well now.

 

[Prgrmerror]

Glad to hear all is well. Operator error is hard to accept sometimes