Honda Valkyrie F6C Forum banner
1 - 10 of 10 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Has anyone heard anything from jimmy lately? I ordered my black ceramacoat slip on's 3/28 l believe and was told would ship end of April.. Emailed him again at the end of April and didn't sound like there ready. Just responded with you'll get your pipes.... So tried back this last week twice and no response. I don't care how long it takes but a heads up would be cool! Anybody else have any luck?
 

·
Registered
Joined
·
216 Posts
Its a good thing you bought them already though. With so little demand for aftermarket parts for the Valkyrie, I don't see them even producing them for long.
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #4 ·
Great... Hopefully don't have to do a dispute on pay pal... Like i said don't care how long it takes within reason but a response goes along way!
 

·
Registered
Joined
·
216 Posts
True. I do make a lot of phone calls even if a few of them are to simply say "Sorry, your bike isn't going to be ready today like planned."
 

·
Registered
Joined
·
118 Posts
Torq Master is an independent shop, Jimmy may not always communicate as fast as we do but he is a man of his word. I ordered and received my torque loops and pipes in a timely manner. The sound is great with one baffle in each side pushed all the way to the front.
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #8 ·
Torq Master is an independent shop, Jimmy may not always communicate as fast as we do but he is a man of his word. I ordered and received my torque loops and pipes in a timely manner. The sound is great with one baffle in each side pushed all the way to the front.
3 weeks with no communication and paid in full just had me a touch nervous.. And I understand this time of year he's swamped. I'm pretty curious to see the finish on the black ceramacoat.i didn't go tubes yet. Do you plan on a power commander or something at some point? To tweak it? I had to 1800vtx's with all the normal go to mods and piped both bikes ran fat on the factory tunes.. So we dialed them in on the dyno with good results the ,2002 retro had Dual shot Gun's from hard chrome only made 94 hp 100 torque . My 05 spec3 F had 2 into 1 drag specialties boom canon put down 102hp and 110 torque ..Im curious if a guy could get say 110hp

out of the new VALKYRIE??!!
 

·
Registered
Joined
·
216 Posts
I had my stock Valkyrie dynoed. 107hp and 112 ft/lbs. I'm sure with with good exhaust and PCV with the correct map you could probably get about 5 more out of each. Too bad no one has taken their bike to Dynojet to get a free map.made of the Torque master pipes with loops. I'd buy a pair if a PCV map was available.
 
1 - 10 of 10 Posts
Top