Honda Valkyrie F6C Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
88 Posts
Discussion Starter · #1 ·
At low speeds when I turn the bars, I hear a squeaking noise like rubber rubbing on rubber or plastic on plastic. I looked in the manual but I don't see a rubber bushing showing up that may be worn. Does the same when sitting still and I wiggle the bars any at all. Yes it has close to 20K miles on the clock. Bike feels tight and I have no issues other than the noise.

Ideas???????????
 

·
Registered
Joined
·
58 Posts
I very seldom use 1st gear anymore. I just hope I don't have that 2nd gear issue like my M109 had...I hope.
 

·
Registered
Joined
·
34 Posts
If you have a windscreen make sure it’s mounted within 2mm of the lower wire clamp on the bars...that will alleviate the creaky noise from the wires\cables
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top