[superjim]

Anyone installed auxiliary driving lights in the lower cowl? There are two connectors there to plug in the lights. But where is the connector for a switch? I'm installing the shark lights from BikeMP3. Instructions suck to start with but there for a Goldwing and talk about removing the control panel to located the connector for the switch or the jumper wire in my case. We don't have a control panel on the F6C so now I need to find this connector to power the lights.

 

[blackwidow]

I think this can help you http://powersports.honda.com/documentum/MW01/08V70-MJR-670.pdf

 

[superjim]

Ah, yes. Looks like it is behind the left side panel just above the fuel door key cylinder. Perfect. Thanks, Blackwidow. Now, back to the garage.


BTW: Ever notice how the first thing in almost every set of instructions is: "Remove the negative battery cable"? Really? Want to check the air pressure in your tires?
Remove the negative battery cable first!

 

[ledany]

@blackwidow : Thanks a lot for the pdf, I may have the use of it in order to install the Cree lights I bought from China

 

[superjim]

The instructions say to remove the upper front cowl and the left radiator cover but neither are required. The lower front cowl can be removed and installed with the upper in place. Just have to pry the upper forward a bit. Absolutely no need to removed the radiator cover. The panel for the fuel key cylinder will pop off after the one screw is removed. Pretty easy installation. Note: If anyone orders the shark lights from bikemp3, they send a large tube of what is supposed to be silicone. Mine was really bathroom latex caulk with silicone. It did not work well. I had to use some real 100% silicone. I do like the lights a lot.