[shadow2001]

I want to install an Admore Light Bar on my Valkyrie, but I don't have a service manual yet. Can someone tell me which wire colors correspond to the following:

Tail Light wire
Brake Light wire (Green w/ black?)
Right Turn Signal wire (Light blue?)
Left Turn Signal wire (Orange)
Ground (Solid Green)


I got some of this from another forum, but they are not giving straight answers and some appear to be guessing. I am not great with electrical and would appreciate precise answers, or I will have to take it to a dealer and that might be costly.

Thanks in advance for any help you can give.

:nerd:

 

[145236]

tail light = light green/black wire
brake = green/yellow
ground = green
right turn = blue
left turn = orange
note there is a wire color change after the 3 pin connector
brake = black/white
ground = black
tail = black/yellow

 

[shadow2001]

You rock.. thanks!!!

 

[ynzr]

I ordered an AdMore light bar today. I really appreciate seeing the color codes for the wiring. I would like to ask if anyone here can tell me the easiest place to locate the wires so I can tap into them. I presume that is somewhere beneath the seat. Any information is appreciated.

 

[shadow2001]

There is a plug that connects under the front left-hand side under the seat. It extends the whole way under the seat and to the back of the bike. Undo the gray clip and cut the black electrical tape and rubber wrap and you can get to the wires. It is pretty easy to find.

 

[ynzr]

Great! I do appreciate the information. It's so nice to have a place to begin searching for wires.

 

[Roodie]

I added extra light on the rear of my Valkyrie , I used Skene lights , you can google the name , I saw them at another Valkyrie forum , you can add more lights to the same system .
I believe with admore , you can not add anything , you are stuck with what they send you , that's what they told me

 

[shadow2001]

Thanks, Roodie... you got any pictures? I like the Admore but there is no good place to mount the bar that is not low around the license plate.

Anyone have any better suggestions how to mount lights back there?

 

[ynzr]

My Valkyrie came with the luggage rack and backrest. I too wanted to get the light up higher for better visibility in tight traffic. I attached the supplied bracket to the backrest bar so that the AdMore light sets about 3" above the luggage rack. A side benefit is that the light reflects off of the luggage rack making it look like there are more lights than there really are. I've had several positive comments on the conspicuity it provides and the mounting/wiring was very easy (once I decided what I wanted to do).

 

[ynzr]

(Hopefully I attached the pictures correctly) This is how I positioned and attached my light bar. It is very visible.